Cleaning Oil System; Jaw Insert Replacement; Drive Belt Inspection; Machine Storage - RIDGID 1224 Operator's Manual

1224 Threading Machine
NOTE! RIDGID Thread Cutting Oil produces high qual-
ity threads and maximizes die life. For in-
formation concerning its use and handling, refer
to the labels on the oil containers. Disposal of the
oil should be in accordance with government
regulations.

Cleaning Oil System

1. Place container under chip pan drain plug. (Figure 32)
2. Remove plug and drain oil.
3. Slide out draw tray and clean with mineral spirits.
4. Lift up and remove insert tray. Use a putty knife to re-
move pipe scale, metal shavings and dirt. Clean with
mineral spirits.
5. Remove oil filter and clean screen in solvent and
blow out with compressed air if available.
6. Use putty knife to remove sludge build-up on bottom
of chip pan.
NOTE! Do not operate machine with filter screen re-
moved.
Figure 32 – Cleaning Chip Pan and Oil Filter

Jaw Insert Replacement

NOTE! When teeth on jaw inserts become worn and fail
to hold pipe or rod during operation, replace
entire set of jaw inserts. Clean teeth of jaw in-
serts daily with wire brush.
1. Place screwdriver in insert slot and turn 90 degrees in
either direction.
2. Place insert sideways on locking pin and press down
as far as possible.
3. Hold insert down firmly with screwdriver, turn so
teeth face up.
To Remove
Figure 33 – Replacing Jaw Inserts

Drive Belt Inspection

The Drive Belt should be periodically inspected for
proper tension.
pressure (4 Ibs.) is adequate tension. If belt shows sign
of wear, it should be replaced.

Machine Storage

Motor-driven equipment must be kept indoors or well
covered in rainy weather. Store the machine in a locked
area that is out of reach of children and people unfamiliar
with threading machines. This machine can cause se-
rious injury in the hands of untrained users.

Service and Repair

Service and repair work on this Threading Machine
must be performed by qualified repair personnel.
Machine should be taken to a RIDGID Independent
Authorized Service Center or returned to the factory. All re-
pairs made by Ridge service facilities are warranted
against defects in material and workmanship.
When servicing this machine, only identical replacement
parts should be used. Failure to follow these steps may
create a risk of electrical shock or other serious injury.
Ridge Tool Company
Screw Driver
Insert
Locking
Pin
To Replace
" deflection of belt under moderate
1 /
8
WARNING
WARNING
WARNING
PRESS
DOWN
Teeth
23