Echo 99944200418 Installation Instructions Manual page 3

b
lade
install harness clamp
NOTE
Some models require installation of harness clamp. If your unit does
not have a clamp follow these directions.
1. Remove shield and gear case as an assembly.
a. Loosen two (2) screws (M) that clamp the gear case to the
shaft.
b. Remove locating screw (N) at the top of the gear case.
c. Pull shield and gear case assembly from the drive shaft assem-
bly.
NOTE
Prevent the flexible drive cable from sliding from the drive shaft
housing. If cable does slide free, clean dirt from cable and re-lubri-
cate with lithium based grease prior to re-assembly.
2. Remove front handle.
a. Remove screws and nuts and back plate from
handle.
b. Remove handle.
3. Install clamp.
a. Slightly spread clamp and slide up drive shaft.
b. Do not tighten clamp at this time.
install handle
NOTE
The Barrier Bar is required when using grass or weed blades. Units
equipped with U-Handles do not require installation of the Barrier
Bar.
SRM's with 4-screw front handles
1. Position front handle on shaft and install Barrier Bar using four (4)
5x35 mm screws and (4) new nuts included with kit. Handle must
be at least 10 inches (250 mm) from center of rear handle grip.
2. Adjust handle position for comfortable operation, and tighten
screws securely.
c
onversion
/
barrier bar
k i
it nstallation
N
i
nstructions
M
M
3