Advertisement
6-2-2 Frequency tuning by double click on spectrum
It is possible to "visually" decide to which frequency you would like to tune the receiver by double-clicking directly on the
spectrum or waterfall. The minimum resolution is 1 kHz.
6-2-3 Frequency tuning by mouse drag on spectrum
Note: CENTER button in TUNING panel must be unchecked.
A faster way to quickly change frequencies "visually" on the spectrum is to hover your mouse inside the grayed out
range of the IF filter until the mouse pointer changes to a horizontal double arrow, then drag the mouse either left or
right on to the spectrum while pressing the left mouse button.
(Tuning by mouse drag)
6-2-4 Frequency tuning with "center" button ON
With this setting, the yellow tuning dial line will always represent the
center of the frequency scale. Double clicking somewhere on the
spectrum will shift the whole spectrum to the double-clicked frequency
being the new center of the frequency scale. Doing so while in waterfall
mode, will be the easiest way to understand the procedure.
10
Advertisement
