Installing Into Video Monitors - Sony BKM-142HD Maintenance Manual

Installing into Video Monitors

Each adaptor can be installed in any input option slot.
(The BKM-129X is installed into the left SLOT 1 of
the BVM-D9H/D14H series video monitor. However,
each adaptor can also be installed into the SLOT 1.)
1
Remove the cover of an input
option slot on the rear panel of
your video monitor.
2
Insert the adaptor.
3
Push the adaptor in until it is
firmly seated in the connector
inside your video monitor.
4
Tighten the both screws to retain
the adaptor.
Notes
• Disconnect the AC power plug before installing or
removing adaptors.
• Be sure to install any adaptor into the left SLOT 1. If
no adaptor is installed into the SLOT 1, the picture
may not be displayed correctly.
Cover of an input option slot
11
(E)