Table of Contents
Advertisement
Quick Links
Pan Tilt
WiFi Pan Tilt Camera
PT7131/PT7131W
B EF O RE Y OU BE G IN
Please unpack the box carefully and identify that all the parts are present.
The Camera is suitable for indoor use.
Check the voltage of the power supply. Make sure you use the recommended power
input (5.0V DC, 1.5A). Use of incorrect voltage is not covered by the warranty.
Do not attempt to open the casing to access the Camera. Damage caused to the
product by tampering with the casing is not covered by the warranty.
Do not aim the camera at the sun or similar intense light.
The interval time of powering the camera on and off must be more than 10 seconds
otherwise it will cause serious damage to the CPU.
When you update the cameras, please ensure you:
- connect the camera directly to a computer using a network cable
- close other programs and windows on the computer
- keep the power connected when updating the firmware
PT7131 v1.0
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Tenvis PT7131
Summary of Contents for Tenvis PT7131
- Page 1 When you update the cameras, please ensure you: - connect the camera directly to a computer using a network cable - close other programs and windows on the computer - keep the power connected when updating the firmware PT7131 v1.0...
- Page 2 PR OD U C T D E S CRI PTION WiFi Pan Tilt Camera can be set up in minutes for instant monitoring and live viewing on your Mac or Windows computer and 3G Smartphone - all via your wireless network router or switch For optional recording, simply install the recording software to your Windows PC and configure it to your particular requirements.
- Page 3 P A C KA GE C O N T E N TS Power Adaptor WiFi Camera with Antenna Software Installation CD CA M E RA IN S TA L LAT I ON Begin by screwing the antenna and bracket to the camera and power the camera using the power supply provided.
- Page 4 C AME RA SE TUP conti nued Please note that if you are using the camera on a wireless network you will need to first configure the camera for wired use, before you programme your wireless settings in to it. Insert the Installation CD into your PC CD drive and the installation screen should appear automatically.
- Page 5 C A M E R A S ET U P c o nti nu e d After searching, the software will give one of 3 results: Connected IP cameras are located on the LAN - All the IP cameras will be listed and will be displayed in the result field as shown below.
-
Page 6: Network Configuration
C A M E R A S ET U P c o nti nu e d Network Configuration Configure the Network parameters from this page. • DHCP checkbox: If checked, the device will obtain an IP from the DHCP server (ensure the Router, with which the device connects, has a DHCP function).
Need help?
Do you have a question about the PT7131 and is the answer not in the manual?
Questions and answers