Zhone 6738 User Manual page 123

ZHONG 6738 User Manual
There are 2 primary methods used in the Wi-Fi Protected Setup:
Push button: An actual push button on the hardware or through a simulated
push button in the software. (This is an optional method on wireless client).
PIN entry, a mandatory method of setup for all WPS certified devices.
– Enter STA PIN: If you select it, you need to enter the
station PIN from client.
Use AP PIN: The PIN is generated by AP.
–
If you are using the PIN method, you will need a Registrar (access point/wireless
router) to initiate the registration between a new device and an active access
point/wireless router. (Note: The PBC method may also need a Registrar when
used in a special case where the PIN is all zeros)
In order to use the push-button for WPS authentication, you must ensure that the
network card support the function. if it supports, you need not to do any
configuration. You can press the WPS button directly to enable the WPS function.
Set WPS AP Mode: You can choose Configured or Unconfigured.
Device PIN: WPS has three access modes: Button, STA PIN and AP PIN.
Device pin is the pin code of AP PIN.
Select SSID: Select a SSID for configuring the security settings.
Network Authentication: This page provides 9 types of network
authentication modes, including Open, Shared, 802.1X, WPA, WPA-PSK,
WPA2, WPA2-PSK, Mixed WPA2/WPA, and Mixed WPA2/WPA-PSK.
- Open Mode: No password is needed for the SSID connection.
- Shared Mode
117