Datavideo HS-1300 Instruction Manual page 23

If the network settings are wrong then you may not be able to access the HS-1300. Always keep a note of
the last IP settings used and change these settings carefully to avoid problems.
Target IP address – This IP address is the location on the local network, or the internet, where the software
can talk to the HS-1300. By clicking the Target IP address you can enter a new address, once entered click
Save Setup. The next time the Image Import/Export Software is opened, it will try to contact the switcher
on this new Target IP address.
Network – This option in the yellow menu column allows you to change the network options on the HS-
1300. When delivered from the factory the default static IP settings should be:
Addr Mode: Static (a manually set IP address that does not change even after power cycling the HS-
1300 unit)
Target IP address: 192.168.100.101
Network Mask: 255.255.255.0
Gateway: 192.168.100.1
DHCP Setup - If the IP set up method is changed to DHCP then each time the HS-1300 is started, it may be
given a different IP address by the network. Only use this method if you know how to find the HS-1300 on
the internal IP network. A device on the network (usually a router or server) will automatically assign an IP
address to the HS-1300. The other settings such as IP address, Subnet Mask and Gateway may appear blank
within the Switcher Image Import/Export software as these would be automatically set by network
router/DHCP server.
23