Troubleshooting - Panasonic i-Shaper ER-GD60 Operating Instructions Manual

Removing and mounting the blade
Removing the blade
Hold the trimmer and push the
blade with your thumb.
Mounting the blade
Fit the mounting hook (B) into the blade mounting (A) on the
trimmer and then push in until you hear a click.


12
ER-GD60_40_ME.indb 12

Troubleshooting

Perform the following actions.
If the problems still cannot be solved, contact the store where
you purchased the unit or a service center authorized by
Panasonic for repair.
Problem
Until problems are solved, please
follow each procedure as follows;
1. Charge the trimmer.
2. Clean the blade and apply oil.
3. Replace the blade.
The trimmer has become
blunt.
4. Have the battery replaced by
Operating time is short.
Charge the battery for
approximately 8 hours
Trimmer stopped
continuously to rejuvenate it.
functioning.
If few uses remain even after
charging, the battery has reached
the end of its life. (Fluid may be
leaking due to degradation at the
end of battery life.)
Contact an authorized service
center for repair.
Insert the appliance plug into the
The trimmer cannot be
charged. trimmer firmly.
Apply oil. (See page 11.)
Makes a loud sound.
Confirm that the blade is properly
attached.
Action
(See page 8.)
(See page 11.)
(See this page.)
an authorized service center.
3/9/2017 1:22:36 PM