Cleaning - Panasonic i-Shaper ER-GD60 Operating Instructions Manual

Cleaning

• Clean the trimmer and the blade after each use.
(If not cleaned, the motion will become poor and the sharpness
will worsen.)
• Make sure that the trimmer is turned off.
• Remove the attachment and blade. (See pages 10 and 12.)
►With water
• Do not wash the appliance with water.
Doing so may cause malfunction if put in water.
Blade and the attachment
1. Clean the blade and the
attachments with running water.
• Rinse with water and shake up and
down several times to remove the
water.
2. Wipe off the water with a towel and
let it dry naturally.
3. Apply the oil to the blade after
drying. (See this page.)
4. Attach the blade and attachment to
the main body.
ER-GD60_40_ME.indb 11
►With the brush
1. Brush off any hair trimmings from the
main body and from around the blade.
• Do not rub dustproof rubber (c)
strongly with brush.
2. Brush off the hair trimmings from the
blade edge.
3. Brush any hair trimmings out from
between the stationary blade and the
moving blade while pressing down the
cleaning lever (d) to raise the moving
blade.
4. Apply the oil to the blade. (See this page.)
5. Attach the blade and attachment to the main body.
Lubrication
• Apply the oil to the blade before and after each use.
Apply a drop of the oil to each indicated
point.
Attach the blade to the main body, turn
on the power and allow to run for
approximately 5 seconds.
Failure to apply the oil may cause the
following problems due to rust, wear or
burn out.
‑ The trimmer has become blunt.
‑ Shorter operating time.
‑ Louder sound.


11
3/9/2017 1:22:36 PM