Related Manuals for Vertex Water Products PureWaterCooler PureChill PWC-9100
Summary of Contents for Vertex Water Products PureWaterCooler PureChill PWC-9100
- Page 1 PureWaterCooler PureChill Water Dispenser OWNERS INSTALLATION OWNERS INSTALLATION OWNERS INSTALLATION OWNERS INSTALLATION MANUAL MANUAL MANUAL MANUAL Floorstanding Model PWC-9100...
-
Page 2: Table Of Contents
Table of Contents Page 1.0 Introduction 2.0 Receiving 3.0 Product Description 4.0 Installation 5.0 Operation 6.0 Leak detection 7.0 Filter Monitor 8.0 Filter Replacement 9.0 Trouble Shooting Guide 10. Specifications 11. Warranty List of Figures Fig. 1 Flow Schematic Fig. 2 PWC-9100 Assembly Fig. -
Page 3: Introduction
1.0 Introduction The Vertex PureWaterCooler™ products are a means to produce good-tasting, safe water without using bottles of stored water. The PureChill model PWC-9100 described here is made for floor-standing use. Please read all the instructions in this manual before operating the PureWater- Cooler™. -
Page 4: Product Description
3.0 Description 3.1 Assembly The model 9100 provides water at 2 temperatures, hot and cold, dis- pensed from one spigot. The flow schematic is shown in the figure below. Water flows from the filtration system into the auxiliary reservoir. This tank is at the same level as the one gallon chilling chamber, which is filled by the auxiliary reservoir. -
Page 5: Fig. 2 Pwc-9100 Assembly
Cold Water Button Key Lock (Safety Button) Hot Water Button Control Panel To Dispense Cold Water: Press Cold Water Button. To Dispense Hot Water: Top Cover Press and release Key Lock Button then press Hot Water Button. Chilling Chamber Auxiliary Reservoir Control Panel Drip Tray Hot Tank... -
Page 6: Fig. 3 Back View Of Cooler
3.2 Rear View On the back of the cooler are the main power switches; one for heat- ing and one for cooling. When heating or cooling is occurring, indicator lights on the front panel will turn on. The hot temperature is fixed at a nominal 180°F and is controlled with a thermostat mounted on the outside of the hot tank. -
Page 7: Installation
4.0 Installation 4.1 Positioning the Cooler There are some precautions to take when positioning and using the PureWaterCooler™. See the items in Figure 4a and 4b. In addition, the cooler must be located near the supply water, and for the “R” version with re- verse osmosis filter, there must be access to a drain trap to which the reject water from the RO is delivered. - Page 8 Do not place cooler next to Be sure to use correct power oven or dishwasher. Keep voltage. Plug power cord out of direct sunlight. directly into electrical socket. Figure 4b Installation Precautions 4.2 Cooler Water Connections When received, the water connections on the back of the cooler have color coded tube sections with red shipping caps on them.
-
Page 9: Fig. 5 Saddle Valve
4.4 Feed Water Connections To connect the feed water, use the supplied self-piercing saddle valve to con- nect to the cold water supply line under the sink. Attach the 1/4” tubing to the compres- sion fitting on the side of the valve. Clamp the saddle valve over the copper or plastic feed line (cold water only). -
Page 10: Fig. 7 Quick Connect Fittings
4.5 Quick Connect Fittings The standard tubing connections on the PureWaterCooler™ are of Quick Connect O-ring seal design and manufacture. Use the tubing and follow the instructions below to make the connections. If you cut the tubing make sure it is a square cut, fits squarely in the fitting, and seals properly. Figure 7 Quick Connect Fittings... -
Page 11: Operation
5.0 Operation 5.1 Start Up a. Connect feed water line and all tubing according to instructions. Turn on source water valve. Open door of cabinet to expose filtration system. b. Disconnect the orange tubing from the bottom of the 2nd stage carbon filter and place a pan or bucket underneath the filter to catch water. - Page 12 5.2 Tank Drain Occasionally, it may be desirable to drain the storage tanks. There is a drain plug on the back of the cooler. See Figure 3. First, make sure both power switches (cold and hot) are off. Leave the cooler plugged in. The cooler must be moved so that the water can be drained into a container to collect the water (about 3 1/2 gal).
-
Page 13: Leak Detection
6.0 Leak Detection System This cooler is equipped with a mechanical leak detector and shut off valve. It is located behind the filters in the base of the cabinet. If water leaks to the bottom of the cooler, the leak detector valve will close and shut off the feed water to the filters and the cooler. -
Page 14: Filter Replacement
8.0 Filter Replacement The filter elements must be replaced at regular intervals to maintain the quality of the water. The “F” Model 9100F has 2-stages of mechanical filtration, the “R” model 9100R has 2-stages of mechanical filtration plus additional RO membrane. The fil- ters are accessed through the lower front door panel. -
Page 15: Trouble Shooting Guide
9.0 Trouble Shooting Guide Problem Cause Solution Check that power cord is plugged Panel Not Lit No Power Confirm that no water is at leak probes. Controls Not Set Turn on cold power switch on back Will Not Cool ... -
Page 16: Specifications
8.0 Specifications S516 Model No. PWC-9100 Voltage/Frequency AC110V Dimensions (L) 16 x (W) 13 x (H) 16 1/2 13"W x 15"D x 41.5"H Weight (empty) 60 lb. 42 lb. .5 gal. Hot Water Tank Capacity .25 gal. Cold Water tank Capacity 1.0 gal. -
Page 17: Warranty
LIMITED WARRANTY Vertex Water Products (“Manufacturer”) sell its products through independent retailer dealers (“Dealer”) who re- sell to the end-user customer. In this limited warranty, “Vertex” refers to Vertex Water Products and not to the Dealer. WHO IS COVERED BY THIS WARRANTY This limited warranty covers only the first purchaser of the Vertex PureWaterCooler™... - Page 18 SHALL INCLUDE, BUT NOT BE LIMITED TO, LOSS OF ANTICIPATED PROFITS, BUSINESS INTERRUPTION, LOSS OF USE OR REVENUE, COST OF CAPITAL, OR LOSS OR DAMAGE TO PROPERTY OR EQUIPMENT. Contact information: Vertex Water Products 5138 Brooks Street Montclair, California 91763 800-627-2146 www.vertexwater.com email: inquiries@vertexwater.com...
- Page 19 PWCM-4 08/15 Copyright 2009 VERTEX INDUSTRIALS, INC.