Advertisement
Quick Links
Quick-Start
Guide
Product specifications are subject to change without notice.
Due to ongoing development, the actual product may vary from
images shown.
This product contains chemicals known to the State of California
to cause cancer, birth defects and other reproductive harm.
This product is not a toy! (14+) Recommended for ages 14 and
up. Adult supervision required for ages under 18 years old.
Contains small parts, keep out of reach of children 3 years of
age and younger.
Distributed in the US by:
Firelands Customer Service/Product Support
1133 Libra Drive, Lincoln, NE 68512
www.firelandsgroup.com
1-800-205-6773
customerservice@firelandsgroup.com
Full manual available to download from: www.Ares-RC.com
Transmitter
Distributed in the UK by:
J Perkins Distribution Ltd,
Lenham,
Kent, UK
ME17 2DL.
www.jperkins.com
QS Guide Part Number: 000580-001
Part Number: KNNA1000
To download the full Owner's Manual
& Technical Information Guide, please
visit www.Ikonnik-RC.com or scan the QR
code with your smart phone.
Distributed in Australia by:
Model Engines (Aust.) Pty. Ltd.,
Unit 1, 158-168 Browns Road,
Noble Park,
Victoria,
3174,
Australia.
www.modelengines.com.au
Ph (03) 8793 5555
warranties@modelengines.com.au
MADE IN CHINA
Advertisement
Related Manuals for IKONNIK KA-6
Summary of Contents for IKONNIK KA-6
- Page 1 This product is not a toy! (14+) Recommended for ages 14 and & Technical Information Guide, please up. Adult supervision required for ages under 18 years old. visit www.Ikonnik-RC.com or scan the QR Contains small parts, keep out of reach of children 3 years of code with your smart phone.
- Page 2 QUICK-START GUIDE This Quick Start guide is written for the KA-6 Transmitter. If you have the PTF (Pair to Fly) version, your model comes complete with a pre-installed Hitec Red-enabled receiver. Simply pair (connect) with your existing 2.4GHz Hitec or Hitec Red-enabled transmitter using the pairing guide on last page of this Quick Start guide.
- Page 3 Your KA-6 is equipped with functionality which automates the pairing procedure. Check the pairing operation of your KA-6 transmitter and receiver by following steps 4 – 8. Remove the components from the box and ensure you have the following items:...
- Page 4 OFF after powering down your model. In the event of signal loss the KA-6 is equipped with a fail-safe function which operates across all 6 channels and must be set independent of the pairing process.
- Page 5 Delta Mixing Mode 1 and Mode 2 stick configurations are catered for on the KA-6. To change modes reverse the switch on the fascia panel, remove the rear case of the transmitter and swap the spring and the ratchet mechanism from one stick gimbal to the other.
- Page 6 QUICK-START GUIDE To fine-tune the four primary controls the KA-6 features digital trim buttons, located adjacent to the main stick gimbals. For clarity, trim center is indicated by an audibly longer beep tone. Digital Trim In use the optimum operating...
Need help?
Do you have a question about the KA-6 and is the answer not in the manual?
Questions and answers