gETTing sTaRTED
Manually
if you choose not to use the included setup cD for
adding additional computers or wireless devices, you
can manually add these items to your network .
1 . locate the wireless-network-connections option
on your computer or wireless device .
2 . select your Belkin router from the list of available networks . You
can identify your Belkin router by locating the network name
(ssiD) from the card located underneath the foot of your router .
3 . enter your network password (located on
your network information card) .
Your wireless device will take a few moments to connect to your
network . if the connection is not made the first time, try this
process again . if you still have difficulty connecting to your network
after trying this process a few times, see the "troubleshooting"
section in this manual for help with connecting to your network .
note: in some cases you may be prompted to select the
security type . it is printed on the card for your convenience .
Using the Wps button
1 . start WPs Push Button connection (WPs PBc) on your
computer or other Wi-Fi device that you would like to connect
wirelessly to your router . Often there will be a button for this
purpose in software that came with the device, or a physical
"WPs," "PBc," or "security" button on the device itself .
2 . Within two minutes, press the WPs button on your router .
the WPs light (small light above WPs button) will blink green while
it listens for your Wi-Fi device . Once a connection is established, the
light will turn green and then go out . if a connection is not established,
the light will blink amber . You may repeat the process to try again .
You can repeat this process for each WPs-enabled
device you'd like to add to your network .
12