RAB Lighting YBLED 3 pin PCT Installation Instructions

YBLED 40W-60W INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We'd like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: marketing@rabweb.com
YBLED Button PC
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
Fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required for
safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH
THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
Make certain power is OFF before installing or maintaining fixture.
WARNING:
LOCATION
Select a location on a structurally sound, flat wall or pole. Fixture should be located on wall or pole at least 18" below any overhang
or other structural detail. Fixture must not be recessed.
MOUNTING TO WALL
1. Secure the fixture to a sturdy wall. Using the mounting
arm as a guide, mark the 3 mounting holes. Drill 3/16"
pilot holes and use provided Lag Bolts (3) to mount to
wooden surface or use appropriate mounting hardware
(not supplied) suitable for the mounting surface.
2. Install the 2 bottom Lag Bolts first. Screw in the Lag
Bolts so that there is about 3/8" of space under the
head.
3. Place the fixture on these 2 bottom Lag Bolts. Install
the top Lag Bolt then tighten the other 2 bolts.
4. Loosen screw and remove the Arm Cover.
5. Knock out the appropriate Conduit Knockout on the
Arm Cover to route input conduit. Use appropriate
conduit connectors as required by code. Connect wires
as shown in wiring diagram. Push all wires back into the
Housing Arm. Be careful not to pinch wires.
6. Secure the Arm Cover and tighten screw.
7. Apply weatherproof silicone sealant around the edge
of the Housing Arm and the wall. This is especially
important with an uneven wall surface.
Housing Arm
Arm Cover
®
YBLED 3 pin PCT
Lag Bolts (3)
Conduit Knockout
Arm Cover
YBLED 5 pin PCT
YARM24 MOUNTING
1. Secure the Interlocking Mounting Clamps around the
YARM24 using the provided truss screws, locknuts and
hex-nuts.
2. Mount the YARM24 to a sturdy wall. Using the YARM24
mounting plate as a guide, mark the 4 mounting holes.
Drill 3/16" pilot holes and use provided Lag Bolts (4) to
mount to wooden surface or use appropriate mounting
hardware (not supplied) suitable for the mounting
surface.
3. Remove the Arm Cover by loosening the screw. Remove
the Clamp by loosening the 2 screws on the Clamp.
4. Knock out the arm-entry knockout on the Arm Cover.
Secure the YARM24 and the Clamp in the Housing Arm
and tighten the clamp screws.
5. Knot wires in YARM24 for strain relief and feed wires
from the YARM24 into the Housing Arm. Make the
necessary wiring connections in the Housing Arm.
Connect wires as shown in wiring diagram. Push all wires
back into the Housing Arm. Be careful not to pinch
wires.
6. Secure Arm Cover and tighten the screw.
Housing Arm
Clamp
.
YARM24
Interlocking Mounting Clamps
Lag Bolts (4)
YBLED LC