Table of Contents
Advertisement
APEX
3 SERIES MIG PENDANT MANUAL
®
Idle Screen Buttons
The Idle Screen – see FIGURE 9 – will change depend-
ing on which menu button has been selected. Some
items in the Selection button windows will change
depending on system configurations.
1. AUTO HEIGHT
• Short Press – Turns Auto Height on and off in
weld mode
2. SETUP
• Short Press – Navigates to the Setup Screen
3. PASS
• Short Press – Switches to the next pass in the
weld program (if available)
4. N/A
• No Effect
5. TEST/WELD
• Short Press – Switches between weld and test
modes (Image shows system in Weld Mode)
6. LEFT TOGGLE (White Border)
• Changes the value displayed in the top left box
(in this example it will change the value in the left
dwell box)
7. STEERING KNOB
• Rotate – Moves the oscillation in and out
• Short Press – Centers the oscillation
• Long Press – Starts/stops oscillation test
8. RIGHT TOGGLE (Gray Border)
• Changes the value displayed in the top right box
(in this example it will change the value in the right
dwell box)
9. WIRE FEED/AMPS
• Short Press – Wire Feed/Amps options
• Long Press – Navigates to the Jog Screen
10. DWELL
• Short Press – Dwell options
• Long Press – Navigates to the Jog Screen Dwell
11. OSCILLATION
• Short Press – Oscillation options
• Long Press – Navigates to the Jog Screen
Oscillation
12. TRAVEL/VOLTS
• Short Press – Travel/Voltage options
• Long Press – Navigates to the Jog Screen
Figure 9 - Idle Screen
13. START/STOP
• Short Press – Starts or stops welding or testing
14. SECTOR
• Short Press – Switches to the next sector if
multiple sectors are enabled
Current sector is displayed here at the center of the screen
near the sector icon.
15. Short Press – stops the welding sequence
and all motion
• Twist Release
* Important! This is not an emergency stop button.
Power is still being applied to the system. The system
will ask you to wait as it resets.
B-7
OPERATION
Advertisement
Table of Contents
