Radio Menu; Radio/Band Settings (Full Configuration Mode) - Cambium Networks cnReach N500 User Manual

cnReach N500 User Guide

Radio Menu

The Radio menu contains all configuration parameters associated with the radio / air interface. This
includes physical layer parameters like transmit power and frequency but also network topology and
addressing for the air interface protocols.

Radio/Band Settings (Full Configuration Mode)

This page provides information on the installed radio modules. If you are configuring a dual radio you'll
see Radio 1 and Radio 2 as shown below. For single radios you will only see Radio 1.
For 900 MHz radios, this page sets whether the unit will be operating in ISM/Unlicensed band or
MAS/Licensed band.
– ISM band (902-928MHz) - Unlicensed- a range of frequencies is used and the radio may
hop between RF channels within the band.
–
MAS band (928-960MHz) – Licensed - specific frequencies are used for transmit and
receive and the radio maintains those frequencies at all times.
Once the band is set, the Radio/RF settings page will display only information relevant to the chosen
band.
For 220/450/700 MHz radios there is nothing to set on this page.
Additional information about radio firmware, serial number and regulation region is shown here.
phn-4673_003v000 (November 2018)
2-14
System Configuration