Page 1
BARTEC Integration Manual MC9000ex – Series Mobile Computer MC92NOex RFID Blatt 1/9...
Page 2
BARTEC Integration Manual 1. Assembly Housing BRICK Drill 7 holes (1,0mm ) and 4 holes (5,5mm) with the fixture in the lower housing. Press 4 inserts into the big holes. Lead the 7 wires (each with different colour) through the drillings.
Page 3
BARTEC Integration Manual Drill 7 holes (1,0mm ) and 4 holes (5,5mm) with the fixture in the lower housing. Press 4 inserts into the big holes. Lead the 7 wires (each with different colour) through the drillings. (LiY 0.08mm², d >...
Page 4
BARTEC Integration Manual 2. Installation RFID Reader (GUN/BRICK) LF-Reader Insert the LF reader into the upper housing. Solder appropriate wires on the LF board as shown in the picture and fix them with UV-glue. Apply Sikaflex in the sealing area of the housing.
Page 5
BARTEC Integration Manual HF-Reader Insert the HF reader (HF board, HF antenna and HF UHF interface) into the upper housing. Solder appropriate wires on the HF board as shown in the picture and fix them with UV-glue. Apply Sikaflex in the sealing area of the housing.
Page 6
BARTEC Integration Manual UHF-Reader Insert the UHF reader into the upper housing. Solder appropriate wires on the UHF board as shown in the picture and fix them with UV-glue. Apply Sikaflex in the sealing area of the housing. Put the RFID lower housing on the upper housing and press them together.
Page 7
BARTEC Integration Manual UHF-Reader with external antenna Apply the appropriate plate on the RFID lower housing. Lead cable of the external antenna through the opening of the RFID lower housing. Fix the RFID lower housing and external antenna with 4 washers and 4 screws.
Page 8
BARTEC Integration Manual Connect the antenna connector with the UHF reader as shown in the picture and fix it with UV-glue.Secure the connector with Sikaflex. Put the RFID lower housing on the upper housing and press them together. Fill the resin into the RFID housing (without empty...
BARTEC Integration Manual 3. Close Housing BRICK Lay the top housing on the bottom housing and slide it in the way of the arrow. Also for the external antenna versions! Lay the top housing on the bottom housing and slide it in the way of the arrow.