12. Reduce The Risk of Unintentional Starting
Make sure switch is in the off position before plugging in.
•
13. Never Leave Tool Running Unattended
Turn power off. Don't leave tool until it comes to a complete stop.
•
14. handle Work Material with caution
Wear leather gloves when handling work pieces.
•
Sharp edges and burrs can cause personal injury.
Support long pieces of material through bend.
•
15. don't force Tool
It will do the job better and safer at the rate for which it was designed.
•
16. don't Over Reach
Keep proper footing and balance at all times.
•
17. do Not Use damaged Tooling
Tooling that shows signs of wear or is damaged should be replaced before continuing use.
•
18. Install Tooling in correct Orientation
Install Form Die Assembly with Clamp Arm towards long bending arm.
•
Install Pressure Die Assembly with bronze end towards clamping arm.
•
See diagram below (Figure #1, below).
•
fig. 1
19. keep Jancy Bender Properly Maintained
Ensure that sufficient hydraulic fluid is in the reservoir (at least 3.5 gallons of Mobile DTE 24 or equal,
•
100 SUS - 350 SUS at 100
Inspect hoses and fittings for cracks and leaks. Repair or replace before operating machine.
•
Grease main pivot assembly after every 40 hours of use.
•
20. Only Use Recommended fluids and Accessories
Use only approved fluids and lubricants on this machine (refer to page 9).
•
Consult the owner's manual for recommended accessories. The use of improper accessories may cause
•
injury to persons.
IMPORTANT: KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
4
important safety instructions
o
F).