Refrigerator Use; Install Cleanflow™ Air Filters - Kenmore 106.5171 Series Use & Care Manual

Install CleanFlow™ Air Filters
(on some models)
On some models, your refrigerator's accessory packet includes
two air filters, which must be installed prior to use. On some
models, the air filters are already installed at the factory.
The air filter reduces the buildup of odors. This helps to maintain
a cleaner environment inside the refrigerator.
Installing the Air Filters (on some models)
The filters should be installed in two separate locations.
Location 1:
Install one of the filters behind the vented door, which is located
(depending on your model) along either the rear or left interior
wall near the top of the refrigerator compartment.
1. Remove the air filter from its packaging.
2. Lift open the vented door.
3. Snap the filter into place.
4. Close the vented door.

REFRIGERATOR USE

Location 2:
Install the other filter in the filter housing assembly, which is
located along an interior side wall of the crisper and/or
convertible drawer.
NOTE: There are two housing assemblies. Use one for one of the
CleanFlow™ Air Filters, and use the other for the
CrisperKeeper™ Produce Preserver pouches. Do not install
Air Filters and Produce Preserver pouches in the same housing
assembly. See "Install CrisperKeeper™ Produce Preserver" for
additional information.
1. Remove the air filter from its packaging.
2. Lift up on the housing in order to remove it from its mounting
3. Snap the filter into place on the rear of the housing.
4. Place the housing back on the mounting tab along the wall.
tab along the wall.
5