Support; Warranty; Battery Disposal Information; Compliance Information - Recon Snow2 User Manual

Support
For service and support, tutorials, and FAQs, go to: http://reconinstruments.desk.com
Warranty
http://reconinstruments.desk.com/customer/portal/articles/520749‐warranty
Battery Disposal Information
http://reconinstruments.desk.com/customer/portal/articles/843025
Compliance Information
FCC Compliance Class B Digital Device
This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
18
FCC Declaration of Conformity
Snow2 (FCC ID: ZW5008) and Recon‐Ready Remote (ZW5001)
comply with FCC standard CRF 47 Part 15 subpart B and
subpart C – section 15.249. Operation is subject to the
following two conditions:
• This device may not cause harmful interference, and
• This device must accept any interference received,
including interference that may cause undesired operation.
Industry Canada Compliance
Snow2 and Recon‐Ready Remote were certified with IC
numbers 9717A‐008 and 9717A‐001, respectively. These
devices comply with Industry Canada licence exempt RSS
standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
Cet appareil est conforme avec les normes de l'Industrie
Canada‐sans les standards RSS (s). L'utilisation est soumise
aux deux conditionssuivantes: (1) cet appareil ne peut pas
provoquer d'interférences et (2) cet appareil doit accepter
toute interférence, y compris les interférences qui peuvent
causer un mauvais fonctionnement de l'appareil.