Technical Information - AEG FAVORIT 34502VI0 User Manual

Problem
The anti-flood device is on.
After the checks are completed, activate
the appliance. The programme contin-
ues from the point of interruption.
If the problem occurs again, contact the
Service.
If other alarm codes appear, contact the
Service.
10.1 If the washing and drying
results are not satisfactory
Whitish streaks or bluish layers on
glasses and dishes
• The released quantity of rinse aid is
too much. Adjust the rinse aid selector
to a lower position.
• The quantity of detergent is too much.
Stains and dry water drops on glasses
and dishes
• The released quantity of rinse aid is
not sufficient. Adjust the rinse aid se-
lector to a higher position.

11. TECHNICAL INFORMATION

Dimensions
Electrical connection
Water supply pressure
Water supply
Capacity
Power consumption
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
2) If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian
energy), use the hot water supply to decrease energy consumption.
Width / Height / Depth
(mm)
Refer to the rating plate.
Voltage
Frequency
Min. / max. (bar / MPa)
1)
Cold water or hot water
Place settings
Left-on mode
Off-mode
Possible solution
Close the water tap and contact the Service.
• The quality of the detergent can be
the cause.
Dishes are wet
• The programme is without a drying
phase or with a low temperature dry-
ing phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
Refer to 'HINTS AND TIPS' for
other possible causes.
2)
ENGLISH
596 / 818 -898 / 555
220 - 240 V
50 Hz
(0.5 / 0.05 ) / (8 / 0.8 )
max. 60 °C
0.50 W
0.50 W
15
12