Advertisement
RESTROOM DIREC T
distributed by
Abusive testing
The tap has undergone rigorous abusive testing
to ensure that it can withstand substantial forces
and impacts typical of a commercial and public
bathroom environment.
Tools required
To install this unit you will need (4) screws, and appropriate fittings
Torx T15 screw driver – long handle
Electrical drill with 1
⁄
" drill bit
3
8
Qty 4 Raw plugs (suitable for wall type fixing to)
7mm flat head screwdriver
Flat terminal block screwdriver
Tap spanner
Spanner 1
⁄
"
1
2
Sharp knife/blade
Pan head screws. Size
⁄
" dia toggle or masonry type
13
64
Conduit as per local electrical regulations
Electrical
Input voltage/Frequency: 220-253V 50 Hz
Isolated by switch fuse spur or RCD as appropriate
Current 6.6 Amps
Cable spec 3 core PVC 1.5mm cross sectional area
Local electrical regulations must be adhered
to when installing or repairing the product
Rated power: 1600 W
Operating temperature range: 32° – 104°F
Standby power consumption: Less than 0.5 W
Water operation
Water flow rate: 4 l/min
Water temperature control: Thermostatic mixer recommended (not supplied)
Water pressure required: 1-8 Bar
1 ½" BSP isolated valve required for service
Water supply cleanliness and biological growth
In some countries there are regulations or guidelines that require
temperature controlled water supply systems (such as that supplied
to the Dyson Airblade Tap hand dryer) to be subjected to regular
cleaning to minimize any biological growth.
To enable you to meet these regulations, the Dyson Airblade Tap
hand dryer has been designed and tested to withstand internal
cleaning both with hot water up to 203°F and with sodium hypochlorite
at a concentration of 0.45%.
Dyson is unable to advise regarding the details of the cleaning
you should carry out because this will be specific both to the
applicable regulations and to your water supply system.
When carrying out internal cleaning of the Dyson Airblade Tap
hand dryer, please be aware of any safety considerations when
using hot water or chemicals. Dyson will not be responsible
for any injury caused by this process.
For further information please contact Dyson.
888-397-6622
airbladeinfo@dyson.com
www.dysonairblade.com
704 . 937. 2673
www.RestroomDirect.com
Advertisement
