Advertisement
RESTROOM DIREC T
distributed by
Locating the soap dispenser
The infrared sensing zone for air activation extends along each
tap branch. Therefore, it is the user's hand route to the soap
dispenser that is most important to prevent nuisance activation.
The soap dispenser should be located at least 2
width of the tap. This is so the user can reach around the side of
the branch.
The soap dispenser should be located at least 2
the branches so that the sensors are not activated.
It is also important to note that the user may reach diagonally
across for the soap and this path must not go through the
sensing zone.
Front on view showing
soap dispenser
clear zone.
2
⁄
"
23
64
350mm minimum
Over head view
showing soap
dispenser clear zone.
2
⁄
"
23
64
For further information please contact Dyson.
888-397-6622
airbladeinfo@dyson.com
www.dysonairblade.com
704 . 937. 2673
Mounting the motor bucket (AB09/AB10)
The motor bucket cannot be mounted upside down.
The motor bucket cannot be installed above the sink.
3
⁄
" outside the
23
to floor/wall.
64
Only the following is advised.
⁄
" above
23
64
2
⁄
"
23
64
Mounting the motor bucket (AB11)
Metal enclosure assembly
This Dyson product is designed so the motor unit is located
behind the stud wall. The vertical wall studs must be constructed
so as to allow the metal enclosure to be fitted between them.
One of the horizontal wall studs must be fitted a) so it holds the
main weight of the metal duct and the unit, and b) so it is in the
correct position for the tap stem.
2
⁄
"
23
64
385mm minimum
www.RestroomDirect.com
⁄
" minimum clearance from bottom of motor bucket
15
16
L N
3
⁄
"
15
16
385mm minimum
Advertisement
