Dyson Airblade TAP AB11 Pre-Installation Information

RESTROOM DIREC T
distributed by
PRE-INSTALLATION INFORMATION
Sink specification guidelines
The Dyson Airblade Tap hand dryer is compatible with
most sink types.
Do not use plugs within the plug holes in sinks.
Due to high velocity air and water being in close proximity,
there is a chance of some water dispersion outside
the sink dimensions.
Sinks with highly polished surfaces should be avoided
e.g. reflective chrome.
Porcelain or brushed metal are ideal.
Fig.1
13 ⁄ " minimum
25
32
350mm minimum
Fig.3
15 ⁄
5
385mm minimum
32
Sink dimensions
(All internal measurements unless otherwise stated)
Fig.1 Width of sink minimum: 13 ⁄
25
32
Fig.2 Maximum depth of sink for Long Neck Tap (AB10) only: 7
(External measurement of vessel/pedestal sink).
For further information please contact Dyson.
888-397-6622
airbladeinfo@dyson.com
www.dysonairblade.com
350mm minimum
" minimum
", Front to back of sink minimum: 11
13
⁄ "
7
8
704 . 937. 2673
Tap mounting
The tap stem (measured from the outside diameter) should
be mounted ⁄ " – 1
19
32
When multiple taps are installed side-by-side, tap centers
should be a minimum of 22
11 ⁄ " from tap center to a side wall. This allows sufficient
27
64
space for mounting the motor bucket horizontally as well as
enough space for users at the sink (shoulder to shoulder).
Do not place the downward facing water sensor of the tap over
a reflective surface, such as the drainage hole. (Fig.4)
Fig.2
Fig.4
Fig.3 Minimum distance from tap center to top of sink (AB11 only) 3
Front edge of sink (all types – pedestal, recessed, slab) to wall minimum 15
⁄ "
16
Internal depth of sink minimum (for all taps): 3
www.RestroomDirect.com
⁄ " from the outside edge of the sink.
9
16
⁄ " apart and a minimum of
53
64
350mm minimum
385mm minimum
385mm minimum
⁄ "
15
16
⁄ ".
15
16
⁄ ".
5
32