Red Sea REEFER User Manual page 11

RED SEA REEFER™ Skimmer
With all of the internal components assembled, lower the skimmer body
onto the base so that the hole on the side is aligned with the pump inlet.
Secure the body in position tightly with the 4 screws provided.
Manual Neck Cleaner
Familiarize yourself with the operation and assembly/
disassembly of the manual neck cleaner.
To operate the cleaner, use the handle recess in the lid to
rotate it either in the clockwise or anti-clockwise direction.
This may be slightly stiff when dry however it will rotate
easily when in regular use.
The lid/wiper can be removed as a single unit by pulling
it up and out of the foaming section of the neck.
Due to the conical shape of the foaming section a small
force may be required to reinsert the wiper/lid to the cup.
12
The wiper is held in the lid by snap connectors on both
sides of the handle and can be removed for cleaning.
Should it become necessary the wiper blades can also be
removed for more thorough cleaning and/or replacement.
The REEFER Skimmers are provided with an extra-long
™
drainage tube with an elbow connector and a watertight
valve. Push the rubber tube onto the drainage outlet at
the bottom of the collection cup and set the angle of the
elbow to give a convenient path for the drainage tube to
the front of your sump for easy periodic collection of the
accumulated waste.
Ensure that the O-ring is in position and assemble the collection cup by
pushing it down into the neck of the skimmer body. This will be easier if
the O-ring is wet.