www.CarnivalKingSupplies.com info@carnivalking.com GAS CREPE MAKER General Safety Precautions To ensure safe operation, read the following statements carefully. These precautions should be followed at all times. Failure to follow these precautions could result in injury. • Do not touch any hot surfaces. •...
www.CarnivalKingSupplies.com info@carnivalking.com gAS CREPE MAKER General Installation • T h ese appliances are intended for use with Natural Gas or LPG Regulators used with this appliance must comply with the local standards Appliances may be converted by qualified personnel. A conversion kit is supplied for the orifice spud.
5 - 10 minutes and repeat the process using less oil everytime. ( 6 - 8 times ) A well seasoned plate should be dark brown and have a shine. Carnival King Gas Crepe Maker Features • Stainless steel construction.
Page 5
www.CarnivalKingSupplies.com info@carnivalking.com GAS CREPE MAKER Instructions for Gas Conversion: MODEL SERIES 382GCM16 Warning Improper installation, adjustment, alteration, service or maintenance can cause property damage, injury or death. Read the installation, operating and maintenance instructions thoroughly before installing or servicing equipment. This conversion kit shall be installed by a qualified service agency in accordance with the manufacturer’s instructions and all applicable codes and requirements of the authority having jurisdiction.
Page 6
www.CarnivalKingSupplies.com info@carnivalking.com GAS CREPE MAKER Instructions for Gas Conversion: MODEL SERIES 382GCM16 Remove the regulator pin, invert, and reinsert: • From NAT Gas to LP Gas: To operate with LPG gas, the regulator must be changed to operate at 10” WC •...
Page 7
www.CarnivalKingSupplies.com info@carnivalking.com GAS CREPE MAKER Instruction for Normal Operating Sequence: Burner Operation: To start main burners, turn the burner valve knob to “ON” position then press the igniter. Derating at altitudes above 2000 ft (610m): Ratings of gas utilization equipment are based on sea level operation and shall not be changed for operation at elevations up to 2000 ft (610m).
Need help?
Do you have a question about the 382GCM16LP and is the answer not in the manual?
Questions and answers