Advertisement
Legend Crimp Tool
The Legend Crimp Tool is designed for use with copper crimp rings in combination with brass insert fittings, meeting the
requirements of ASTM F1807 or plastic insert fittings meeting the requirements of ASTM F2098. The Legend Crimp Tool should
only be used on crimp fittings and flexible plastic tubing meeting the requirements of ASTM F876 / 877 or ASTM F2769.
Making A Crimp Connection
1. Cut tubing squarely. Remove any burrs.
2. Slide crimp ring over end of tubing. Insert fitting into end of tubing until it stops at
shoulder, covering all three barbs. Position crimp ring 1/8" to 1/4" from end of tubing and
fitting shoulder.
3. Place the crimping end of tool jaws around the center of the crimp ring and press the
handles together. Be certain to fully close the jaws of the tool.
4. Check for proper crimp with the Go/ No-Go gauge.
1
Using GO/NO-Go Gauge
Legend Valve & Fitting, Inc.
300 N. Opdyke Rd.
Auburn Hills, MI 48326
2
Item # 508-280
Installation Guide
3
www.legendvalve.com
800-752-2082
4
Auburn Hills, MI
www.legendvalve.com
Advertisement
Table of Contents
Related Manuals for Legend 508-280
Summary of Contents for Legend 508-280
- Page 1 Installation Guide The Legend Crimp Tool is designed for use with copper crimp rings in combination with brass insert fittings, meeting the requirements of ASTM F1807 or plastic insert fittings meeting the requirements of ASTM F2098. The Legend Crimp Tool should only be used on crimp fittings and flexible plastic tubing meeting the requirements of ASTM F876 / 877 or ASTM F2769.
- Page 2 If compression is too small, repeat steps 1-3; except rotate the bolt head counter- clockwise to the next lower number. If adjustment is required higher then 3, or lower than 0, then replace the tool. Auburn Hills, MI Legend Valve & Fitting, Inc. Item # 508-280 www.legendvalve.com...
Need help?
Do you have a question about the 508-280 and is the answer not in the manual?
Questions and answers