Table of Contents
Advertisement
PC Setup
PC Setup
This plasma display provides Plug and Play capability, meaning that the PC adjusts automatically to its settings. The plasma display
sends configuration information (EDID) to the PC using the Video Electronics Standard Association (VESA) Display Data Channel
(DDC) protocol. It perceives the recommended 640x480 resolution at 60 Hz to provide the Advanced Television Systems Committee
(ATSC) 480P or 480-line progressive-scan television video signaling standard that is part of the Digital Television (DTV) standard for
60 frame-per-second video.
1. To get the best picture quality, adjust the PC graphics card to a 640x480 resolution and 60 Hz screen scanning rate. Resolutions
over UXGA cannot be displayed.
2. Connect the signal cable from the PC video output port to the plasma display RGB1 INPUT port, or the PC's DVI (Digital Visual
Interface) output port to the plasma display RGB2 INPUT (DIGITAL RGB) port. If the PC graphics card does not output analog and
digital RGB simultaneously, connect to only one of the RGB ports. If you connect the PC to both, set the plasma display to either
RGB1 or RGB2 and the other mode is set automatically.
3. Connect the audio cable from the PC to the AUDIO INPUT jacks on the plasma display. If using a sound card, adjust the PC sound
as required.
4. Turn on the PC and the monitor.
5. Turn on the display by pressing the POWER button on the monitor's remote control.
6. Use the INPUT SELECT button on the remote control to select the RGB 1 or RGB 2.
7. Check the image on your plasma display. Adjust the brightness and contrast. If the picture is not clear, try changing the PC reso-
lution and/or refresh rate. If you cannot adjust the refresh rate of the PC graphics card you may need to install a different card.
8. To see a normal picture, match the VGA mode and DVI signal (640x480, 848x480, 852x480). (Refer to the Operation section of
this manual.)
NOTE: Depending on the graphics card, DOS mode may not work if you use a DVI-I cable.
NOTE: Avoid keeping a fixed image on the monitor's screen for a long period of time.The fixed image may become perma-
nently imprinted on the screen. Use the Orbiter screen saver when possible.
14 Plasma Display
( )
( )
( )
( )
R
L
RS-232C INPUT
RGB INPUT
EXTERNAL SPEAKER
DVI INPUT
(CONTROL/SERVICE)
EXPANDED
AUDIO INPUT
RGB OUTPUT
INPUT
Advertisement
Table of Contents
