Avantco 177GRCLP User Manual page 10

User Manual
IGNITION AND COOKING INSTRUCTIONS
The WARM BUTTON is not visible when the
unit is in a low position.
Read All Instructions before lighting!
Ignition
1. Check to make sure that IGNITION, COOKING, and WARM are OFF before switching on
the gas. The inner pot should be taken out when first used. This can help avoid injuries due
to improper operation.
2. Slightly press the IGNITION button until you hear a sound, and make sure the WARM
button is on. Then release IGNITION and make sure the WARM button is fixed in the
engaged position.
3. Put the inner pot in when the WARM button is on. Then press COOK.
NOTE:
• Do not put your eyes close to the hole for ignition confirmation,
it is dangerous.
• Make sure WARM is engaged before putting the inner pot in.
10
1. Turn gas valve to ON position.
2. Take out the inner pot when first used during lighting.
3. Press down the IGNITION BUTTON until you hear a sound.
4. Check to ensure WARM BUTTON is also at ON position.
5. Press down COOK BUTTON. COOK BUTTON goes up
automatically when cooking is finished.
6. The cooker keeps warm after COOK BUTTON resumes OFF
position.
7. Pull WARM BUTTON upwards when warming function is not
needed.
8. Turn gas valve to OFF position.
If ignition does not occur in 5 seconds, turn the burner control(s)
off, wait 5 minutes, and repeat the lighting procedure.
www.AvantcoEquipment.com