Table of Contents
Advertisement
Remarks:
After factory reset, the paired list of transmitter will be deleted. When
you turn on the transmitter again, it will enter pairing mode automatically,
but it won't connect to device automatically, you should re-pair and
connect to devices.
In the status of off mode, reset the BTT025A ,it will enter the process of
turn on, pairing, factory reset, enter pairing. The LED indictor will
change from blue LED on , red and blue LED on simultaneously, to blue
LED and red LED flashes alternately, and then enter pairing mode
directly.
In the status of standby mode, reset the BTT025A , it will enter the
process of turn off, factory reset , turn off. The LED indictor will change
from red LED on , red and blue LED on simultaneously, to LED indictor
off, and then turn off.
Care and maintenance
Read the following recommendations carefully before using BTT025A.
Following these you will be able to enjoy this product for many years.
Keep it dry and don't put it in the dump place to avoid the product's
internal circuit being affected.
Keep the product away from direct sunlight or hot places. High
temperatures will shorten the life of electronic devices, destroy the
battery or distort certain plastic part.
Don't expose the product to cold areas. It may damage the internal circuit
board.
Don't try to disassemble the product as it may get damaged if you are not
professional.
Don't let it fall down onto the floor or other hard surfaces. The internal
circuit might get damaged.
Don't use intensive chemical products or detergent to clean the product.
Don't scratch the surface with sharp things. It may get damaged by
sweat.
In case the transmitter doesn't function properly, please send it to the store
that you bought it. The staff will help you to solve the problem.
6
Advertisement
Table of Contents
