Getting Started; Charging The Transmitter; Reeling The Cable - K-Mate BTT025 User Manual

 Getting started

1. Charging the transmitter

First using—You must charge the battery fully before first using.
Low power—It means low power if the red LED of the transmitter flashes
during using. At this time, you need to recharge the transmitter.
The charging steps as follows:
1) Connect the USB charging cable into the USB port of PC or charger;
2) Connect the other end of USB charging cable to charging port of the
transmitter.
RED light on→Charging
RED light off→Finished charging
3) It will take about 2 hours to finish charging.
Warning:
The battery is recyclable.
Batteries (battery pack or batteries installed) shall not be exposed to
excessive heat place, such as sunshine, fire or the like.

2 Reeling the cable

1) Please reel the audio line into the cable slot if you don't use the product.
It is convenient to carry and store. Please operate it as shown below .
2