Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Verizon FiOS-JenMod1
Summary of Contents for Verizon FiOS-JenMod1
- Page 1 JENNIC WIRELESS MODULE User Guide Model FiOSJenMod1 ...
-
Page 2: Table Of Contents
Contents Chapter 1 Introduction ..............3 Purpose ........................... 3 Chapter 2 Frequently Asked Questions .......... 3 Chapter 3 Installing the JENNIC HAN module ........ 4 Pre-requisites ........................4 Step by Step Guide ......................7 ... -
Page 3: Chapter 1 Introduction
Chapter 1 Introduction Purpose The (FiOS-JenMod1) HAN module is a plug-in JENNIC controller for your FiOS- BHR4 Gateway. It has an integrated antenna and is all you need for enabling your Gateway to connect your SmartCloud system to supported JENNIC home automation devices such as Motion Sensors, Thermostats, Alarm systems, Smart lights and more. -
Page 4: Chapter 3 Installing The Jennic Han Module
Chapter 3 Installing the JENNIC HAN module Pre‐requisites Verify that you have everything you need: The HAN module The FiOS-BHR4 Gateway It must be powered on, connected to the network and operating normally. - Page 5 An open slot for the HAN module on the backside of the FiOS-BHR4...
- Page 6 If another module has been already installed, then it must be removed before you can install the JENNIC HAN module. Please refer to (chapter) for module un- installation instructions. You must be logged in to your home FiOS-BHR4 Gateway as Administrator You can use either the web app or the MyFiOS App (please consult the manual for your Gateway).
-
Page 7: Step By Step Guide
Step by Step Guide Step 1. Remove the HAN module port cover Use a fingernail or a flat-headed screwdriver. -
Page 8: Step 2. Insert The Han Module
Step 2. Insert the HAN module. ... -
Page 9: Step 3. Wait For Notification To Appear Or Enter Han Settings Menu
It can only go in with one orientation. It should slide in and come to a smooth stop with only the extraction finger handle protruding. If the module doesn't slide in very easy then verify that you have it the right way up. The HAN module label faces to the RIGHT when you watch the FiOS-BHR4 gateway from behind. -
Page 10: Chapter 4 Connecting Devices To Your Smartcloud
Chapter 4 Connecting Devices to your SmartCloud TBD ... -
Page 11: Chapter 5 Notices And Declarations
Chapter 5 Notices and declarations Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. - Page 12 This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna.