Care And Maintenance; Trouble Shooting - Titan TTB683SHR Getting Started

TTB683SHR by TITAN
Repair
This product does not contain any parts that can be repaired by the consumer.
Contact an authorised service centre or a similarly qualified person to have it
checked and repaired.
Storage
> Switch the product off and disconnect it from the power supply.
> Clean the product as described above.
> Store the product and its accessories in a dry, frost-free place.
> Always store the product in a place that is inaccessible to children. The ideal
storage temperature is between 10°C and 30°C.
> We recommend using the original package for storage or covering the
product with a suitable cloth or enclosure to protect it against dust.
Transportation
> Switch the product off and disconnect it from the power supply.
> Attach transportation guards, if applicable.
> Do not try to carry the product alone! If it is necessary to lift the product,
always ask another person for help.
> Only transport it by its transportation handle (2).
Tilt the product towards you until it balances on
the wheels. Then move it by transportation handle
(Fig. 17).
> Protect the product from any heavy impact or
strong vibrations which may occur during
transportation in vehicles.
> Secure the product to prevent it from slipping or
falling over.
30

Care and maintenance

Fig. 17
Care and maintenance / Trouble shooting

Trouble shooting

Suspected malfunctions are often due to causes that the user can fix
themselves. Therefore check the product using this section. In most cases
the problem can be solved quickly.
WARNING! Only perform the steps described within these
instructions! All further inspection, maintenance and repair work
must be performed by an authorised service centre or a similarly
qualified specialist if you cannot solve the problem yourself!
Problem Possible cause
1. Product does not 1.1. Not connected to
start
power supply
1.2. Power cord or plug
is defective
1.3. Other electrical
defect to the product
1.4. Overload protection
is activated
1.5. Interlock switch of
the collection box is
unlocked
1.6. Forward/reverse
switch on middle
position
2. Product does not 2.1. Extension cord not
reach full power suitable for operation
with this product
2.2. Power source (e.g.
generator) has too
low voltage
2.3. Air vents are blocked
3. Motor sounds but 3.1. Cutting
does not start blades are blocked
3.2. Forward/reverse
switch on middle
position
TTB683SHR by TITAN
Solution
1.1. Connect to power
supply
1.2. Check by a specialist
electrician
1.3. Check by a specialist
electrician
1.4. Refer to section
"overload protection"
1.5. Check and lock the
interlock ofcollection
box
1.6. Set the switch to
forward " " or
reverse " " position
2.1. Use a proper
extension cord
2.2. Connect to another
suitable power
source
2.3. Clean the air vents
3.1. Refer to section
"overload protection".
3.2. Set the switch to
forward " " or
reverse " " position
31