Table of Contents
Advertisement
PROBLEM
Engine Will Not Start
1. Fuel tank empty.
Using Recoil Starter
2. Engine needs choking & priming.
3. Spark plug fouled or wire disconnected.
Engine Will Not Crank
1. Power extension cord not plugged into machine or
Using Electric Starter
2. Power extension cord damaged.
3. Starter switch damaged or faulty.
4. Key switch turned to "OFF" position.
Engine Stalls or Stops 1. Fuel and 2-Cycle oil mixture ratio incorrect.
After Running
2. Choke control in the "CHOKE" position.
3. Fuel tank empty.
4. Air intake clogged with snow or debris.
5. Spark plug defective or gap set improperly.
6. Water, debris or stale fuel in fuel system.
7. Fuel filter clogged.
Engine Loses Power
1. Fuel and 2-Cycle oil mixture ratio incorrect.
2. Spark plug faulty.
3. Water, debris or stale fuel in fuel system.
Excessive Vibration
1. Damaged, out of balance or bent auger.
2. Loose engine or auger components.
3. Loose or missing flightings.
4. Cracked, severed or frayed belt
5. Bent or loose Idler pulley
Poor Snow
1. Clogged discharge chute.
2. Damaged or bent auger or components.
Discharging
3. Cracked, severed or frayed belt.
4. Belt tension out of adjustment.
5. Auger flightings damaged or missing.
ITEM
SERVICE PERFORMED
Spark Plug
Replace
Engine Cooling
Clean Shroud & Fins
System
Drive Belts
Check For Wear And
Tension
Auger & Flight
Check For Wear, Damage
Shoe
& Replacement
4.2.
MAINTENANCE/REPLACEMENT PARTS
TROUBLESHOOTING
PROBABLE CAUSE
110 Volt outlet.
SERVICE SCHEDULE
Engine Manual.
Engine Manual
Page 10-13
Page 10-13
MAINTENANCE PARTS
Auger Drive Belt
Auger Clutch Control Cable
Auger Flite Shoe Kit for 19" Auger Models
REF.
EACH
USE
HRS
X
14
CORRECTIVE ACTION
1. Fill fuel tank with fresh fuel/oil mix.
2. Move choke control to "CHOKE" position.
Push primer bulb three times.
3. Replace spark plug. Attach plug wire onto
spark plug.
1. Plug power extension cord into machine & into
110 Volt outlet.
2. Discard damaged power extension cord
3. Replace starter switch.
4. Turn key switch to "ON" position.
1. Mix fuel and 2-Cycle oil to 32:1 ratio.
2. Move choke control to "OFF" position.
3. Fill with fuel to proper level.
4. Unclog air intake.
5. Service spark plug.
6. Drain and clean fuel system.
7. Replace with new in line filter.
1. Mix fuel and 2-Cycle oil to 32:1 ratio.
2. Service spark plug.
3. Drain and clean fuel system.
1. Service auger.
2. Service and tighten loose components.
3. Replace flightings.
4. Replace belt.
5. Tighten or replace pulley.
1. Stop engine and unclog discharge chute.
2. Service auger or components.
3. Replace belt.
4. Adjust belt tension.
5. Replace flightings.
5
25
50
HRS
HRS
X
X
2-4618
2-4662
6-1213
100
EACH
HRS
SEASON
X
X
X
Advertisement
Table of Contents
