(models ending with “F”), for increased performance and closer tolerance temperature uniformity. Models TO-152G, TO-152F, TOH-152G & TOH-152F are suitable for laboratory bench or floor mounting. Models TO-235F & TO-330F are suitable only for floor standing.
P a g e Features: • Stainless steel liners (easy clean surface & non corrosive). • Fibreglass insulation for efficiency. • Stainless steel sheathed heating element. • Digital temperature control with over temperature alarm. • Monitoring port hole. • Removable chrome plate shelves. •...
P a g e On the fan forced models a circulating fan blows the air across a heating element mounted behind the ceiling panel, down a rear air duct, and across each shelf level for even temperature distribution. On gravity convection models the element is located at the bottom of the oven. The temperature sensor provides an accurate measure of the temperature inside the oven.
P a g e Limited access to the control parameters is available. The operator can alter the temperature set point and has access to a parameter used for calibration purposes. 4. TO CHANGE THE SET TEMPERATURE: • Use the button to move the cursor, the digit will flash indicating that it can be changed.
P a g e Allow the digit to Press the page Use the up or stop flashing and button to access down arrow to the screen will the sensor enter the sensor display the adjusted correction correction value. value. parameter. In the example above the oven temperature displayed (PV) is 100ºC.
P a g e WARRANTY: Have the following information available when you contact the service department: • Model number and serial number. This is generally found on the exterior of the cabinet in the form of a stick-on label. MODEL NO: SERIAL NO: •...
Page 8
P a g e Standard 12 month Warranty Thermoline Scientific Equipment Pty Ltd ABN 80 000 859 129 (“Thermoline”) Thermoline warrants to the original purchaser that this product will perform to its product specification for a period of 12 months from date of purchase, provided that the installation of the product has been carried out in accordance with the latest version of the manufacturer's instructions and further provided that the use of the product complies with that specified in the relevant specification.