Riello UPS MULTICOM 411 Quick Start

PROFIBUS
CONFIGURATION SWITCHES
The configuration switches are used to set the PROFIBUS node address. Remove the plastic hatch to configure the switches (see
image below). Note that the node address cannot be changed during runtime, i.e. the gateway requires a reset for changes to have
effect.
The configuration is done using two rotary switches as follows: Node Address = (Switch B x 10) + (Switch A x 1)
Note: When removing the hatch and configuring the switches, avoid touching the circuit boards and components.
C M COM 302 ↔
ONNECTION CABLE ULTI
DB9 male connect RJ-45
PIN to PIN
↔
5 2
↔
9 3
↔
8 4
NOTE: Use a twisted pair to connect PIN #9 and #8 of DB9 to PIN #3 and #4 of RJ-45
DIN‐
RAIL MOUNTING
To snap the gateway on, first press it downwards (1) to
compress the spring in the DIN-rail mechanism, then push
it against the DIN-rail as to make it snap on (2).
For additional informations, please download User Manual and GSD file from manufacturer's website.
‐ 0MNACCMC8ENQB ‐
Example:
If the node address should be 42:
set switch A to "2" and switch B to "4".
PROFIBUS DP G
ATEWAY
To snap the gateway off, push it downwards (1) and pull it out
from the DIN-rail (2), as to make it snap off from the DIN-rail.
4
QUICK START MULTICOM 411
PRESENTATION
I
N THE BOX
MultiCOM 302 board PROFIBUS DP Gateway
E
XTERNAL VIEW

PROFIBUS Connector

Configuration Switches

Status LEDs

Reserved

MultiCOM 302 Connector

Power Connector

DIN-rail Connector
‐ 0MNACCMC8ENQB ‐
Connection cable between MultiCOM 302
and PROFIBUS DP Gateway
1