Download Print this page
Ikelite DL1 DS Link Installation And Use

Ikelite DL1 DS Link Installation And Use

Nikon ttl converter, hotshoe kit

Advertisement

Quick Links

DL1 DS Link Nikon TTL Converter Ikelite
NT2 Hotshoe Kit
Product # 46054
Included in the Box
DL1 DS Link Nikon TTL Converter
Plug o-ring # 0136.13 (installed)
Connector protector # 0301.12 (installed)
Waterproof bulkhead cap # 9104.7 (installed)
NT2 Nikon TTL Hotshoe # 46064
Silicone lubricant 1cc tube

Strobe Compatibility

Ikelite DS50 above serial # 75510
Ikelite DS51 above serial # 78700
Ikelite DS125 above serial # 7928
Ikelite DS160, DS161
Ikelite DS200 above serial # 7163
The DL1 DS Link is not compatible with other
»
manufacturers' strobes.
Sync Cord Compatibility
Ikelite Housing to Ikelite Strobes # 4103.51
Ikelite Housing to Two Ikelite Strobes # 4103.52
Ikelite Housing to Ikelite Strobes # 45051
Ikelite Housing to Two Ikelite Strobes # 45052
Use of two strobes requires a dual sync cord. Two
»
strobes cannot be controlled by individual converters
even if the housing is equipped with two bulkheads.

Camera Compatibility

Compatibility may be updated as new cameras are released.
Refer to the product page on our website for up to date
camera compatibility information.

Installation and Use

Installing the NT2 TTL Hotshoe
1.
Depress the tab on the manual hotshoe connector and
gently pull connector ends apart to remove the housing's
manual hotshoe.
2.
Align TTL hotshoe and bulkhead connector ends and
push together until tab clicks into place.
3.
Push hotshoe forward into camera's hotshoe mount.
Make sure that the hotshoe is all the way forward to
ensure proper connection.
The NT2 TTL Hotshoe is only intended for use with
»
compatible Ikelite brand housings.
Attaching the Converter
1.
Remove connector protectors and bulkhead caps from
each connection.
2.
Apply a very thin, even layer of lubricant on all threads,
sealing surfaces, and the exposed portion of the plug
o-ring. Do not allow lubricant to get into the pins and
receptacles of the plug or bulkheads.
Retaining ring
Plug o-ring
Mode button
LED indicator
MADE
IN USA
DL1 DS LINK
Bulkhead

Advertisement

loading

Summary of Contents for Ikelite DL1 DS Link

  • Page 1: Installation And Use

    • Ikelite DS160, DS161 compatible Ikelite brand housings. • Ikelite DS200 above serial # 7163 The DL1 DS Link is not compatible with other » Attaching the Converter manufacturers’ strobes. Remove connector protectors and bulkhead caps from Sync Cord Compatibility each connection.
  • Page 2: Maintenance And Storage

    All other claims of any nature are Turn strobe on. When turned on the DL1 DS Link will be not covered. Except as mentioned above, no other warranty in TTL mode.

This manual is also suitable for:

Nt2