Table of Contents
Advertisement
Note
‡
$IWHU \RX ÀQLVK PDQXDO :L)L VHWXS IRU '6:
the new Wi-Fi network created by DS3880W will
disappear.
‡
If you fail to enter Assisted Wi-Fi Setup mode, power
off DS3880W and power on it, then try again after
successful boot-up.
‡
Make sure that there are no other Philips AirPlay-
enabled devices in Assisted Wi-Fi Setup mode at the
same time. Multiple Wi-Fi networks created this way
may interfere with each other.
Connect your Wi-Fi enabled device to
the newly created Wi-Fi network
The new Wi-Fi network created by DS3880W
only allows access of one Wi-Fi enabled device.
To avoid interference from any other Wi-Fi
devices, you are recommended to temporarily
disable the Wi-Fi function on your other Wi-Fi
devices.
Option 1: Use your iPod touch/iPhone/iPad
1
Select Settings -> Wi-Fi on your iPod
touch/iPhone/iPad.
All manuals and user guides at all-guides.com
2
Select Philips Fidelio AirPlay from the list
of available networks.
Philips Fidelio AirPlay
3
Wait until successful Wi-Fi connection on
your iPod touch/iPhone/iPad.
»
is displayed at the upper left corner
of your iPod touch/iPhone/iPad.
Tip
‡
If Philips Fidelio AirPlay is not in the list, try to scan the
available Wi-Fi networks again.
Use your Wi-Fi enabled PC/Mac
Note
‡
See the user manual of your PC/Mac for how to
connect your PC/Mac to a Wi-Fi network.
‡
During Wi-Fi network connection, do not connect any
network cable to your PC/Mac.
1
Open the Wi-Fi setup tool or control
panel on your PC/Mac.
EN
15
Advertisement
Table of Contents
