Mechanical Adjustments; Electrical Adjustments - Sony CX-JDS22 Service Manual

CX-JDS22/JDS33
SECTION 4

MECHANICAL ADJUSTMENTS

TAPE MECHANISM DECK SECTION
Precaution
1. Clean the following parts with a denatured alcohol-moistened
swab:
record/playback heads
erase head
capstan
2. Demagnetize the record/playback head with a head demag-
netizer.
3. Do not use a magnetized screwdriver for the adjustments.
4. After the adjustments, apply suitable locking compound to
the parts adjusted.
5. The adjustments should be performed with the rated power
supply voltage unless otherwise noted.
Torque Measurement
Mode Torque meter
FWD CQ-102C
FWD
CQ-102C
back tension
REV CQ-102RC
REV
CQ-102RC
back tension
FF/REW CQ-201B
FWD tension CQ-403A
REV tension CQ-403R
16
All manuals and user guides at all-guides.com
pinch rollers
rubber belts
idlers
Meter reading
2.94 – 7.84 mN • m
(30 to 79 g • cm)
(0.42 – 1.11 oz • inch)
0.15 – 0.59 mN • m
(2 to 6 g • cm)
(0.03 – 0.08 oz • inch)
2.94 – 7.84 mN • m
(30 to 79 g • cm)
(0.42 – 1.11 oz • inch)
0.15 – 0.59 mN • m
(2 to 6 g • cm)
(0.03 – 0.08 oz • inch)
6.86 – 17.64 mN • m
(70 to 179 g • cm)
(0.98 – 2.49 oz • inch)
0.98 mN • m or more
(10 • cm or more)
(0.14 oz • inch or more)
0.98 mN • m or more
(10 • cm or more)
(0.14 oz • inch or more)
SECTION 5

ELECTRICAL ADJUSTMENTS

DECK SECTION 0 dB=0.775V
Precaution
1. Demagnetize the record/playback head with a head
demagnetizer.
2. Do not use a magnetized screwdriver for the adjustments.
3. After the adjustments, apply suitable locking compound to
the parts adjusted.
4. The adjustments should be performed with the rated power
supply voltage unless otherwise noted.
5. The adjustments should be performed in the order given in
this service manual. (As a general rule, playback circuit
adjustment should be completed before performing recording
circuit adjustment.)
6. The adjustments should be performed for both L-CH and R-
CH.
7. Switches and controls should be set as follows unless otherwise
specified.
• Test Tape
Tape Signal
P-4-A100 10 kHz, –10 dB
WS-48B 3 kHz, 0 dB
Record/Playback Head Azimuth Adjustment
Procedure:
1. Mode : Playback
test tape
MAIN board
P-4-A100
SPEAKER terminal (J171)
(10 kHz, –10 dB)
L-CH, R-CH
set
2. Turn the adjustment screw and check output peaks. If the peaks
do not match for L-CH and R-CH, turn the adjustment screw
so that outputs match within 1 dB of peak.
within
L-CH
1dB
peak
Output
level
R-CH
peak
Screw
position
L-CH
peak
Used for
Azimuth Adjustment
Tape Speed Check
level meter
+
–
within
1dB
Screw
position
R-CH
peak