Table of Contents
Advertisement
CROSSOVER-AMP
The crossover/amplifier shall be connected like
an ordinary power amplifier, after the
preamplifier.
The level of the signal feeding the bass amplifier
can be adjusted continuously by a trimmer
adjustments at the back of the unit. The
adjustment range is +/- 10dB for both channels
separately. The adjustments have been set to
default values at the factory. Once found the
correct balance, there is little need for further
adjustments.
If one wish to drive the Quad ESL with an
external power amplifier, line level output is
available for the purpose.
Speaker connectors are four pole Neutrik
Speakons. Pins are connected in the following
way:
Pin 1+ = SW +
Pin 1- = SW -
Pin 2+ = ESL +
Pin 2- = ESL -
4
Advertisement
Table of Contents
Need help?
Do you have a question about the SW-S and is the answer not in the manual?