Safety Measures In Normal Operation - Fronius Robacta TC 2000 Operating Instructions & Spare Parts

Safety measures
in normal opera-
tion
12
Use internal directives and checks to ensure that the workplace environment
is always clean and clearly laid out.
Only set up and operate the device in accordance with the degree of protec-
tion shown on the rating plate.
When setting up the device, ensure an all-round clearance of at least 0.5 m
(19.69 in.) from any surrounding objects, e.g. walls, other devices or objects.
The device must be set up at least 1 m (40 in.) away from computers, control
lines and the welding process.
Position the device to prevent welding spatter coming into contact with the
cleaning device.
Before transporting the device, allow parting agent to drain completely.
When transporting the device, observe the relevant national and local guide-
lines and accident prevention regulations. This applies especially to guidelines
regarding the risks arising during transport.
After transporting the device, the device must be visually inspected for dam-
age before commissioning. Any damage must be repaired by trained service
technicians before commissioning the device.
Only operate the device when all safety devices are fully functional. If the safe-
ty devices are not fully functional, there is a risk of
- injury or death to the operator or a third party,
- damage to the device and other material assets belonging to the operator,
- inefficient operation of the device.
Any safety devices that are not functioning properly must be repaired before
switching on the device.
Never bypass or disable safety devices.
Before switching on the device, ensure that no one is likely to be endangered.
Check the device at least once a week for obvious damage and proper func-
tioning of safety devices.
- Only use suitable original parting agent from the manufacturer.
- Observe the information on the parting agent safety data sheets when
handling parting agent. The parting agent safety data sheets may be ob-
tained from your service centre or downloaded from the manufacturer's
website.
- Do not mix the manufacturer's parting agent with other parting agents.
- If damage results from using a different parting agent, the manufacturer
accepts no liability. In addition, no warranty claims will be entertained.
- Used parting agent must be disposed of properly in accordance with the
relevant national and international regulations.