Table of Contents
Advertisement
Using a DHCP server simplifies network management by removing the need to assign IP addresses to
devices manually.
Conditions
•
The DHCP Server feature cannot be used if the Control Box's IP address assignment mode is set to
DHCP.
•
If the Control Box's DHCP server is enabled, make sure that no other DHCP servers are running on the
same network. Having more than one DHCP server on a network can result in network errors.
•
For the following settings, the Control Box delivers the settings of its LAN port to devices: subnet mask,
default gateway address, and DNS server addresses.
PC Programming Manual References
16.2.1 Network Service—[2-1] Server Feature—DHCP(LAN)
4.4.5 Flexible Numbering
Description
To dial another extension user or to access Control Box features, the access numbers (extension numbers
or feature numbers) are required.
[Flexible Numbering Table]
•
Extension Numbers
Extension Numbering Scheme 1–127—Leading Number
Extension Numbering Scheme 128—Leading Number
•
Feature Numbers (cannot be changed)
FWD/DND set/cancel—Internal
FWD/DND No Answer Timer set
PC Programming Manual References
10.2.1 Control Box Configuration—[2-6-1] System—Numbering Plan—Main
Feature Manual References
5.1 Capacity of System Resources
Operating Manual References
4.2.1 Feature Number Table
4.4.6 Floating Extension
Description
Virtual extension numbers can be assigned to resources to make them appear as extensions. This feature is
also known as Floating Station.
These numbers are defined as floating extension numbers and can be assigned as a destination of
incoming calls etc.
Feature
Feature
4.4.5 Flexible Numbering
Default
None
970
Default
712
713
Feature Manual
41
Advertisement
Table of Contents
