Summary of Contents for Louvolite Roller System 32
Page 1
Roller System 32 Side Control ® Fitting & Operating Instructions Louvolite Customer Services Tel: 0161 882 5050 www.louvolite.com Email: sales@louvolite.com...
Page 2
Roller System 32 Side Control ® Fitting & Operating Instructions Carefully unwrap the roller blind and its associated brackets. The brackets are universal and can be fixed in a top, face or side fix position. Note – System 32 has two differing brackets, an idle end and a control end that ®...
Page 3
Use this figure to position the outside of your brackets accordingly whether inside of the recess or outside of the recess 1535mm 1535mm Inside the recess Outside the recess Mark the hole positions before drilling and plugging if necessary. Use two screws in each bracket ensuring that the brackets are level.
Child Safety Your blind will be supplied with either Easybreak connectors attached to the ® operating chain or a cord tidy that will need to be fitted to the wall. Easybreak System ® Two Easybreak connectors are connected to the operating chain 200mm apart. ®...
Page 5
Cord tidy Disposable red tab Remove the disposable red tab by disengaging it from the chain and then pull out the disposable red tab. Disposable retaining thrust washer Disposable red tab Position the cord tidy to the wall at the furthest distance below the roller tube adding appropriate tension to the chain and mark its location.
Page 6
Split the cord tidy and mark the remaining offset hole position before drilling and plugging both location holes if necessary. Screw into the offset hole to fix the back piece of the cord tidy to the wall. Re-assemble the cord tidy with the chain and fix it in previously marked position with a screw through the centre hole.
Page 7
Push fit a cover cap over the screw hole opening. Cover cap...
Page 8
Fitting a face fix cord tidy. Position the face fix cord tidy to the wall at the furthest distance below the headrail adding appropriate tension to the chain and mark its location. Mark the remaining hole position before drilling and plugging both location holes if necessary.
Page 9
Attach the cord cover plate with the screw provided. Push fit a cover cap over the screw hole opening. Cover cap x 3...
Operating the blind. For a conventional roller blind, in order to lower the blind, pull the rearmost length of chain downwards with a smooth and steady pressure. To roll the blind up do the same on the front length of chain. For a reverse roll blind the opposite is true, to lower use the front chain and to raise, use the rear chain.
Page 12
Child Safety - BS EN 13120 Guidelines for Roller Blinds Tensioned System with Cord Tidy If fixing height is unknown Chain length Blind drop size Cord tidy If fixing height known Fixing height Cord tidy Distance between chain & floor Floor Breakaway Connector System If fixing height unknown...