Table of Contents
Advertisement
8
Instruction Manual
Battery and Charging
Note!
IDS-3100 uses a lithium ion battery designed solely for the device. It is to be purchased from ILLUCO or
from an authorized ILLUCO dealer. Using a battery other than the one designed for the IDS-3100, can cause
damage to the unit.
A.
Charging Indicator
There are three indicators that showing the charging status of IDS-3100.
Red blinking:
Green:
Red:
Red & Green
Green:
B.
Charging via USB charging outlet
Prepare the USB charging outlet supplied with IDS-3100.
Insert the USB charging outlet into the charging port of the device and the USB plug into an
charging-outlet.
Note!
Using a USB-port of a PC is not recommended as it will take over 10 hours until the unit is fully charged.
C.
Charging via Charging cradle
Connect the charging cradle to an outlet. Then, insert IDS-3100 to the charging cradle.
The charging time is ca. 3.5 hours.
When the unit is fully charged, the continuous duty time is ca. 2.5 ~ 4 hours.
Note!
IDS-3100 is programed not to work when the device is in charging status.
D.
Battery replacement
①
Prepare a new battery.
②
Pull down the battery cover and open the unit.
③
Remove the existing battery and replace with new one.
④
To close the unit, push up the battery cover.
Low battery: The battery is almost empty and charging requested.
Device is connected for charging (USB cable or Charging Cradle)
The device is in charging status.
(in normal condition, green & red both should be on)
The device is connected for charging and is in charging status.
Charging completed.
USB-
Advertisement
Table of Contents
