Table of Contents
Advertisement
9
Instruction Manual
Automatic shut down
In order to save on electrical consumption, IDS-3100 is designed to shut down the power automatically
after 5 min. idle run.
Maintenance
Note!
The objective lens, LEDs and polarization filters of IDS-3100 must be treated as high quality optical parts.
Use only standard lens cleaning equipment for cleaning and protect them from harmful chemicals.
Cleaning and sterilization
The exterior of the IDS-3100 may be cleaned or sterilized with isopropyl alcohol (70% vol.).
Do not use any kind of disinfectants, acetone or chemicals other than isopropyl alcohol.
Note!
Always apply the fluid to a cloth or tissue rather than the lens itself.
Good approach is to start with breath and then use the fluids for difficult marks to remove.
Alcohol and Acetone are different. Don't be confused and never use acetone for device cleaning incl.
objective lens.
Troubleshooting Guide
Note!
IDS-3100 is reliable and designed for trouble-free operation. Never attempt to open or dismantle the device
for any reason other than battery replacement. The manufacturer and distributors are not liable for
mechanical troubles, property damage, or personal injury caused by the user(s) unfamiliarity with the
manual's instructions.
①
No Power Supply
Recharge the battery and power on again.
If the problem persists, replace the battery with a new one.
When the both tries ended up with failure, contact the ILLUCO A/S Center or your local distributor and
report the problem.
②
LED fails
The LEDs embedded on the IDS-3100 are designed to last 100,000 hours. If any of the LEDs fails, contact
the ILLUCO A/S center or your local distributor.
③
Mechanical malfunction
Please contact the ILLUCO A/S center or your local distributor.
Advertisement
Table of Contents
