Jack Richeson LOBO How To Assemble

Imported Easels by Jack Richeson & Co., Inc. - Kimberly, WI - Phone: 1-920-738-0744 - www.richesonart.com
A. Easel
Frame
With Mast
Pre-drilled
hinge holes
for Step 2.
B. Back
Support
Leg
Step 1
You may select any of the 5 height
positions for your easel frame.
HOW TO ASSEMBLE THE
Lobo Easel
#883201 Made from Lyptus ® Wood
Lyptus
C. Base With
Shelf
Step One:
Attach the Easel
Frame (A) to the
Base ( C ), with the
hardware in Parts Bag 1.
Thread the Knob (with
bolt) through the Plastic
and Brass Washers, the
Base leg, the Slide Guide,
and into a recessed nut
on the Easel Frame.
Tighten. Repeat on
other side.
® is a registered trademark of Weyerhaueser.
Parts Bag 1
1
3 4
1. 2 - Slide Guides
2. 2 - Knobs (with bolt)
3. 2 - Plastic Washers
4. 3 - Wood Screws
5. 2 - Brass Washers
6
7
8
Parts Bag 2
Step Two
Step Two:
Using the 3 screws from Parts Bag 1, mount the hinge on
the Back Support Leg (B) using the pre-drilled holes on the
back of the Base (C).
7/13
2
5
6. 1 - Knob
7. 1 - Bolt
8. 1 - Slide Guide
9. 1 - L-Bracket
10. 2 - Wood Screws
11. 1 - Knob (with bolt)
9
11
10
Parts Bag 3