Related Manuals for Impresind Eliturbo E.L.C. series
Summary of Contents for Impresind Eliturbo E.L.C. series
- Page 1 Air Mixer Eliturbo Install, use and maintenance instructions IST E101.101-ver.11.2015 - EN...
-
Page 2: Table Of Contents
6.2 Suggested use ............................9 6.3 End of season switch off ........................10 7 - Maintenance ..........................10 8 - Dismantling ........................... 10 Impresind Srl Production facility: Via Primo Maggio 24, Gorgonzola (Milano, Italy) ℡ +39 02 95741932 +39 02 95740637 impresind@impresind.it... -
Page 3: Eliturbo® Air Mixer Product Introduction
Eliturbo® air mixer product introduction Eliturbo® is an air mixer that is able to horizontally and vertically even the air temperature, to even the humidity and to reduce the running costs for heating and cooling in large buildings. Eliturbo® uses a special helicentrifugal rotor that mixes the air, it does not create annoying air currents that can bother workers, it is manufactured complying with the security norms and the environment’s hygiene norms. -
Page 4: Generic Information
1 - Generic information 1.1 Receiving the equipment When the package is delivered, the customer is obliged to control the integrity of the packaging and the contents inside. Check the package and its contents, in case of damage due to the transport, the customer has to tick the damage claim box on the transport document counter signed by the carrier and send a copy of it to the supplier. -
Page 5: Technical Information
2 - Technical information 2.1 Technical characteristics ERP 2009/125 Eliturbo® E.L.C. series 2000 2002 EU Reg. 206/2012 Technical data Absorbed power Electrical supply 230V-1_ 50Hz / 400V-3_ 50Hz Fan type Ceiling air mixer Motor protection grade 54/55 Blade version n. of blades Total air movement* 7500 10000... -
Page 6: Installing
3 - Installing 3.1 General warnings for the installation Before proceeding with installing the Eliturbo® units, it is necessary to check if all the components have been unpacked and their integrity checked. The installation an start up of the Eliturbo® units must be done by qualified personnel and complying with the laws in force in the Country where the units will be installed. - Page 7 To anchor the unit to the ceiling use steel chains with a minimum diameter of the wire of 3.5 mm or use steel cables with minimum diameter of 4.0 mm For a quick installation it is suggested to use chains. The anchor points have to be at a sufficient distance to contrast the starting torque;...
-
Page 8: Electrical Connections
3.3 Electrical connections The connection to the electric network must be done by qualified personnel. The electrical cabling and connections must be made complying to the norms. Electrical supply: 230 V 1∼ 50 Hz for units with single phase motor 400 V 3 ∼... -
Page 9: Start Up
Eliturbo® air mixer by interrupting the electric power supply to the product and contact the Technical Assistance of Impresind Srl in any case do not start up the product if any of the above signs are clearly showing To change rotation to the motor, in case the blade is not rotating in the direction of the arrow on the product, first cut off electrical power to the Eliturbo®... -
Page 10: End Of Season Switch Off
Do not apply a room thermostat to command the Eliturbo® air mixer. The Eliturbo® air mixer has to function constantly to contrast the natural stratification of hot air towards the ceiling. For better management of the system and to achieve energy savings it is necessary that the heating system is commanded by a room thermostat positioned at 1,5 meters of height from the floor.