Advertisement
Mounting Hole Variations
The unique design of the XPT actuator lower hinge allows you to easily make adjustments to the installation
angle and lift without drilling new holes in the transom.
Trailing Edge Holes
(Farthest from the Transom):
These two hole options create
more negative angle and less
lift. If the bow is too low
during sea trial, you may
wish to decrease lift.
Stainless Steel Hydraulic Lines
14
XPT System Options
Center Hole:
This is your starting point during installation.
It represents a 10 degree transom angle.
Leading Edge Holes
(Closest to the Transom):
These two hole options create
less negative angle and more
lift. If your boat has more
stern weight, you may wish to
increase lift.
Available upon request.
Call +1.954.427.1400 or email
Premier@BennettTrimTabs.com
for a customized quotation.
13
Advertisement
