WARNING: This product is part of a Personal Fall Arrest and Work Positioning system. The user must follow the manufacturer’s instructions for each component of the system. These instructions must be provided to the user of this equipment. The user must read and understand these instructions before using this equipment.
Product APPLIcAtIoN PURPOSE: Flexiguard Anchorage Systems are designed to provide anchorage connection points for a Personal Fall Arrest ® System (PFAS). WArNINg: Unless otherwise noted, Capital Safety equipment is designed for use with Capital Safety approved components and subsystems only. Substitution or replacement with non-approved components or subsystems may jeopardize compatibility of equipment and may affect safety and reliability of the complete system.
Page 9
FAll clEARAncE: There must be sufficient clearance below the user to arrest a fall before the user strikes the ground or other obstruction. Fall Clearance is dependent on the following factors: • Deceleration Distance • Worker Height • Elevation of Anchorage Connector •...
Page 10
InstallatIon Important: The Flexiguard SafRig Fall Arrest System must be installed by a Qualified Person and the installation must be certified by a Qualified Person as: meeting the criteria for a Certified Anchorage, or capable of supporting the potential forces that could be encountered during a fall.
Page 11
CaUtIon: Personnel shall not be attached to the Flexiguard SafRig Fall Arrest System while it is being positioned. 2. cONFIGure uPrIGHt AssemBLy rOtAtION: The Upright Assembly can be locked at 11° rotation increments with the Rotation Lock Pin Mechanism or allowed to rotate through a range defined by two Rotation Limiters. A.
Page 12
Table 2 – Inspection and Maintenance Log Inspection Date: Inspected By: Competent Components: Inspection: User Person (See Section 1 for Inspection Frequency) Boom and Vertical Inspect the Boom (A) and Vertical Mast (D) for structural defects or damage Mast (Figure 2) including bends, corrosion, etc.
Page 14
LabeLs The following labels must be present on the Flexiguard SafRig Fall Arrest System. Labels must be replaced if they are not fully legible. Contact Capital Safety for replacement labels. All Models 8530595, 8530606 LIFTING EYES PLACE 9504547 PORTABLE COUNTERWEIGHTED JIB BASE SYSTEM WITH ID LABEL HERE CENTER MOUNTED SLEEVE OPERATORS INSTRUCTIONS...
LIMITED LIFETIME WARRANTY Warranty to End User: D B Industries, Inc., dba CAPITAL SAFETY USA (“CAPITAL SAFETY”) warrants to the original end user (“End User”) that its products are free from defects in materials and workmanship under normal use and service. This warranty extends for the lifetime of the product from the date the product is purchased by the End User, in new and unused condition, from a CAPITAL SAFETY authorized distributor.