Torque Settings - Pedelec Groove Next User Manual

Display Description Cause
The red There is a
LED flashes charging fault.
continuously.
10.

Torque settings

DANGER
Only use appropriate tools to tighten screws and bolts. Observe
the specified torque setting. The component manufacturer's torque
settings take precedence (where available). Failure to comply can
result in screws/bolts becoming loose, tearing away or fracturing. If
that happens while you are riding the bike, components may come
off and you could have a severe crash. If screws are overtightened,
components can also be damaged. Tighten all screws and bolts
that are relevant for safety with a torque wrench. This indicates the
corresponding torque in newton metres (Nm).
If no values are shown on the component or component manuals, use the
torque settings from the following table.
Remedy
Unplug the charger from the
mains immediately. If the
problem reoccurs, a new battery
charger is required.
Screw fixing
Front light
Rear light
Handle bars
Drive controller bolt
Foot pedal
Pedal
Seatpost bolt
Seat clamping bolt
Gear lever clamp
Brake lever
Shimano disc brake caliper
Rear wheel axle nut
Front wheel threaded axle
Bolts on the display element
Luggage rack
Smartphone holder
Thread Tightening torque [Nm]
M5 3
M4 Hand-tightened
M4 / M5 M4: 3 / M5: 5
M5 7
M8 35 – 40
9/16 40
M8 12 - 15
M6 12
M5 5
M5 Ref. manufacturer's spec.
M6 6 – 8
M12 30 - 40
M12 12 - 14
M3 0.9
M5 5
M4 3
Original User Guide | Pedelec Groove Next EN-55