Bosch HSB737355Z Instruction Manual page 6

Risk of electric shock and serious injury!
The cable insulation on electrical
■
appliances may melt when touching hot
parts of the appliance. Never bring
electrical appliance cables into contact
with hot parts of the appliance.
Do not use any high-pressure cleaners or
■ Risk of electric shock!
steam cleaners, which can result in an
electric shock.
When replacing the cooking compartment
Risk of electric shock!
■
bulb, the bulb socket contacts are live.
Before replacing the bulb, unplug the
appliance from the mains or switch off the
circuit breaker in the fuse box.
Burn-Back (Fire in burner tube or
chamber)!
In the event of a burn-back, where the flame
burns back to the jet, immediately turn off
the gas supply at the control valve on the
panel. After ensuring the flame is
extinguished, re-light the appliance in the
normal manner. Should the appliance again
burn back, close the control valve and call a
service technician. Do not use the
appliance again until the service technician
has declared that it is safe to do so.
Gas-pressure regulator!
This appliance requires an operating
pressure of 2,8 kPa at the appliance. A
suitable LPG regulator that complies with
the requirements of SANS 1237 must be
installed.
Important Information for the user!
This appliance may only be installed by a
registered LP Gas installer. All registered
installers are issued with a card carrying
their registration number. Ask to be shown
the card before allowing the installation
work to commence and make a note of the
Installer QCC number. Upon completion of
the installation, the installer is required to
explain the operational details of the
appliance together with the safety
instructions. You will be asked to sign
acceptance of the installation and be
provided with a completion certificate. You
should only sign for acceptance of the
installation when the installation is
completed to your satisfaction.
Note that your invoice is required in the
event that you wish make a guarantee
claim.
6
Important Information for the installer!
This appliance may only be installed by a
LP gas installer registered with the Liquefied
Petroleum Gas Association of Southern
Africa. The appliance must be installed in
accordance with the requirements of SANS
10087-1 and any fire department
regulations and/or local bylaws applicable
to the area. If in doubt check with the
relevant authority before undertaking the
installation. Upon completion of the
installation you are required to fully explain
and demonstrate to the user the operational
details and safety practices applicable to
the appliance and the installation.